AR-10 Low-Profile Keymod Free-Float Handguard (12")

In stock
Only 2 left

You get a low profile similar to some lightweight handguards but a full-size free-float barrel nut and thick body for extreme durability.

Comes with three picatinny mini-rails (3.25" long, 7 slots each).

  • Matte black anodized T6 aluminum
  • T-marked picatinny top rail
  • Keymod straight-milled slots on 3,6,9 o'clock (Note some plastic snap-in keymod panels may not be compatible)
  • Dimensions: 12" (305mm) long overall
  • Main body is 40 × 52mm without picatinny segments.  Barrel nut area is 58mm diameter
  • Weight: 490g without picatinny segments

You get:

  • (1) Free-float handguard with barrel nut
  • (3) 7-slot Picatinny segments
  • (1) each of 2.5mm and 4mm hex keys

    Compatible with:

    • AR-10/AR-308 upper receivers with 1 7/16"-16TPI threads and "low" rail height

    Installation Difficulty: 

    Tools required: AR-10-size armourer's wrench, aeroshell grease, AR-10 upper receiver vice block

    Installation notes: Apply aeroshell grease to the upper receiver threads and tighten the nut to between 45-90 ft-pounds of torque. It may help to tighten, loosen, and repeat a couple of times to work in the threads and find a happy place where torque is within spec and the hole lines up for the gas tube.

    More Information
    Handguard Mount Type Free-float
    Handguard Nominal Length 12"
    Barrel Nut Thread 1.25"-18 (AR-15)
    Uses Barrel Nut Type Other/Proprietary
    AR-308 Handguard Rail Height DPMS 'Low' (1.29" over bore)
    Write Your Own Review
    You're reviewing:AR-10 Low-Profile Keymod Free-Float Handguard (12")
    Your Rating