Write Your Own Review
Only registered users can write reviews. Please Sign in or create an account

Front Sight Taper Pin (Long)

In stock

These pins are what you need if you are working with a front sight/gas block combo build. Uncoated steel, 2/0 taper pin with a 1 inch overall length. These are the pins that are used to pin the front sight/gas block combo to the barrel. Note these are 1" long so you'll have to grind/trim them.

  • Raw steel (may have some marks )
  • 1" long

You get:

  1. (1) taper pin 

Compatible with:

  • Any gun that uses the M16/AR-15 front sight block

Installation Difficulty: 

Tools required: Tiny hammer, gaffer tape to prevent marking, grinder

Installation notes: Installation is easy if someone has pre-drilled the taper pin hole into your barrel. If your new barrel does not have this hole it might be tough to get everything lined up.  Removing them can be a real b**tch too but can be made easier by Dremeling the thin end flat first and apply heat to the sight block before wailing on it with a pin punch.