Product Description
A few folks have asked us to cut threads into the end of a barrel. Some times it's an SKS, Rem 700, Type97 or tapered barrels. This is a real pita and takes time to get the barrel od aligned to the id.
This service will get you the threads cut into your barrel
Please put the details of your request in the comment section at checkout, or contact us if you have questions or a special request.
- Adds about 1 week to shipping time for your entire order
- Yes you can send in a barrel form another dealer
- No, refunds are not going to happen on a service request
- Minimum length to fit in lathe is 21 inches from action block to crown for bolt action types unless you remove the barrel
You get:
- (1) Barrel muzzle threads cut in to your spec (most ppl choose 1/2-28 or 5/8-24)
- (1) Cold bluing finish so that you can't see the modification (If applicable)
Compatible with:
- Basically any barrel that you send in
- Send only the barrel not the complete firearm otherwise there will be additional expenses and time required for removing the barrel.