Product Description
Ever wonder why your bolt stays open after the last cartridge is fired from a magazine? Me neither, but this little bad boy gets a little bump from the back of the follower and pivots up to stop the entire bolt carrier group.
You get: (1) Bolt catch Tools required: 3/32" pin punch. Lower receiver vise block not mandatory but helps a lot. Installation Tips: Put some gaffer tape or similar tape on your receiver to prevent marring. Get the roll pin started until it's just peeking into the middle gap. Drop in the bolt catch spring (it's the cylinder spring; the flared spring is for the disconnector), ten the plunger, then the bolt catch. Line up the hole and drive the roll pin through.Product Videos
Custom Field
Product Reviews
1 Review Hide Reviews Show Reviews
-
Gets the job done
Nothing fancy here, this is your standard bolt catch. It fit my stripped lower perfectly and works as it should. Good quality and a good price.