Product Description
The SureFire 3P Eliminator three-prong flash hider features a patent-pending design that greatly reduces muzzle flash — typically greater than 99%—when compared with a plain muzzle. Boasting robust tines built to withstand the rigors of combat, the SureFire 3P Eliminator duplicates the key functional design elements of the SureFire SF3P flash hider, but unlike the latter it cannot be used to mount SureFire SOCOM suppressors.
Precision machined from US mill-certified steel bar stock—including high-precision single-point cut threads for optimum thread interface—the SureFire 3P Eliminator has a black Melonite finish that provides maximum protection under harsh environmental conditions and facilitates cleaning even after extreme use.
SureFire flash hiders are individually inspected for concentricity and alignment and are covered by SureFire’s No-Hassle Guarantee.
NOTE: Not compatible with SureFire sound suppressors.
- Patent-pending design provides greater than a 99% reduction in flash compared to a plain muzzle
- Precision machined from US mill-certified heat-treated stainless steel bar stock
- High-precision single-point cut barrel threads for optimum thread interface
- Inspected for all critical dimensions including concentricity and alignment
- Pilot hole for pin-and-weld on 14.5" rifles
- Black Melonite coating provides maximum protection against harsh environmental conditions and facilitates cleaning after extreme use
- Installation requires no permanent modifications for M4 / M16 / AR15 type weapons
You get:
- (1) Muzzle device in your chosen caliber / thread pitch (either 1/2"-28 or 5/8"-24)
Compatible with:
- Any .22 caliber firearm (including .223, 5.56, etc) with 1/2x28 muzzle threads (if selected)
- Any .308 caliber firearm (including 7.62x39, 7.62x51 NATO, etc with 5/8x24 muzzle threads (if selected)
- Stainless and blued steel barrels
Installation Difficulty:
Tools required: Armourer's wrench, crush washer, and upper receiver vice block or barrel vice
Installation notes: Remember to orient the crush washer with the tapered side towards the gun, as shown in the diagram below:
Manufacturer's Product Numbers:
3P-ELIMINATOR-556-1/2-28, 084871323505
3P-ELIMINATOR-762-5/8-24, 084871324380
